PRESSION CONTROLL FOR ELECTRIC PUMP CONNECTION 1 Inch.

PRESSION CONTROLL FOR ELECTRIC PUMP CONNECTION 1 Inch.

PRESSION CONTROLL 1

The PRESSURE REGULATOR is an automatic electronic device,
designed to control the operation of electric pumps without the use of autoclave tanks.
It performs the following main functions:

1) It controls the uninterrupted and automatic operation of the pump, with constant flow rate and pressure during withdrawal from one or more points of the distribution network. The pump starts when the system pressure is lower than the fi xed (std 1.5 bar). If you want to change this value, you can use the adjustment screw located in the front part under the card protection front panel. The stop occurs when the regulator no longer detects an appreciable output fl ow.
2) Keeps the pump running for a short period of time (5 "approx) after the termination of the levy, thereby avoiding inter alia water hammer caused by the abrupt stopping of the fl ow.
3) In the event of lack of water on the suction side, the system blocks without using level probes or float switches. Operation is restored via a manual reset button.
4) It has a built-in non-return valve for the water hammer.
5) Indicates the operating phases by means of special indicator lights:
- green LED on connection to the electrical system in place
-Led yellow on pump running
-LED bright red lockout conditions due to lack of water in inspiration

CONDITIONS OF USE

Power supply: 220V-240V

Maximum intensity: 10 A

Frequency: 50/60 Hz

Max pump power: 1.1 kW

Attack: 1POLL.

Overall dimensions: 168mm x 228mm

Maximum pressure: 10 bar

Protection: IP65

Max operating temperature: 60 degrees

PRESSION CONTROLL FOR ELECTRIC PUMP CONNECTION 1 Inch.